| CAS No.: | 38891-59-7 |
|---|---|
| Formula: | (C11h12o3)N |
| EINECS: | 500-033-5 |
| Bonding Function: | Structural Adhesive |
| Morphology: | Solvent |
| Application: | Construction, Active Metal Surface, M36 etc |
| Samples: |
|---|
| Customization: |
|---|
Suppliers with verified business licenses
Audited Supplier Product Description
The Hantec-340B is a universal, medium viscosity, high strength adhesive. It is suitable for transition,
interference or clearance fit. Hold the key and shaft, bearing, small motor rotor shaft, bushing,
improve the fit strength of pressure fit, repair worn hole - shaft fit or out of tolerance parts, screw lock seal.
Application
Typical use for bearing and sliding fitting assembly fixed. It is used for fixing cylindrical parts with
maximum radial clearance of 0.10mm. Typical applications: general purpose, holding key and shaft,
bearing, small motor rotor shaft, bushing, sealing of threaded parts and filling of sand holes.
Chemical/solvent resistance
|
Aged under the following conditions and tested at 22ºC |
||||
|
solvent |
TemperatureºC |
Initial intensity residual rate % |
||
|
After 100h |
After 500h |
Afte 1000h |
||
|
engine oil |
125 |
100 |
100 |
100 |
|
unleaded gasoline |
22 |
100 |
100 |
95 |
|
ethyl alcohol |
22 |
100 |
90 |
90 |
|
acetone |
22 |
95 |
95 |
95 |
|
Sodium hydroxide 10% |
40 |
100 |
100 |
70 |
|
Hydrochloric acid 10% |
40 |
100 |
100 |
100 |
|
Water/ glycol (50%/50%) |
87 |
100 |
85 |
85 |
Usage
a) Grease should be removed and cleaned at the glue-coated parts. Metal cleaner is recommended;
b) Uniformly apply the glue solution to the joint part of the workpiece and assemble it according to the conventional method;
c)Set at room temperature for 24 hours;
d)If stored for a long time, shake well when used.
Matters need attention
A) Do not pour the poured gel solution back into the original bottle to avoid contaminating the gel solution.
B) This product contains acrylic acid and hydroxypropyl methacrylate, which can irritate the skin and eyes.
C) In case of accidental contact with eyes and skin when using this product, rinse immediately with clean water.
D) This product should not be used on plastics.
Storage
a) Store in a cool and dry place at 8 ~ 28ºC.
b) Shelf life: two years
Packing specification
50g/piece;250 g/piece
*Note: The performance data above are typical data measured in a laboratory environment with temperature of 25ºCand humidity of 70%. They are only for reference and cannot be guaranteed to be achieved in a specific environment. Please refer to the actual test data when using.
About us
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}