(1) Load the wood on the feeding cart and place electrode after the layer finish.
(2) Push in to the tank and close the door.
(3) Start the system: vacuum pump starts first, when it reaches the set limit, HF power starts automatically to heat.
(4) When HF heat to the set max limit temperature, HF stop and wait, after temperature falls to the min limit, HF generator starts to heat again, during this cycle, vacuum pressure is always near -0.09Mpa, if it falls below set limit, vacuum pump starts automatically.
(5) When the drying cycle finish, the weight sensor will calculate and stop all the system, drying process finish.