Liquid Thermal shock test chamber
Purchasing a liquid thermal shock chamber needs close consideration of the long term operating costs. The specialized liquids used can easily evaporate, causing the loss of thousands of dollars of fluid per year, if not properly contained. Liquid-to-liquid thermal shock testing is typically conducted to apply very strong, repetitive thermal stress to test pieces. It can model a product's ability to withstand thermally-induced size changes, crack resistance, hermetic integrity, and changes in electrical properties. This form of testing provides a very rapid temperature shock recovery of conditions, and it can significantly reduce testing time by requiring shorter soaks and less cycles. The TSB thermal shock chambers have been built to meet the demanding test requirements of Mil-Std 883 method 1011.9, which has become a defacto industrial standard for semiconductor devices.
Serious cost savings
Grande has led the industry in developing a sophisticated test chamber with multiple mechanisms to significantly reduce fluid usage. The new TSB-51 loses just 1.4 grams per test cycle, or less than a liter of fluid per 1,000 cycle test. The recovery system reduces fluid loss through enhanced airtightness, preventing leakage of evaporated thermal fluid from the test area. A fan draws air to a condensing coil that turns evaporated fluid into a liquid, returning it to the baths. The units also include a separation filter for removing water from the thermal fluid. A refrigerated cooling ring at the top of the hot bath helps limit evaporative losses.
Technical parameters:
Model No |
GLTS-021-65-LW |
GLTS-041-65-LW |
Testing method |
Two-liquid bath system with specimen basket transfer |
Test zone size W*H*D(mm) |
200*350*300*2Bath |
260*350*450*2Bath |
Test zone size W*H*D(mm) |
1140*1785*1240mm |
1200*1785*1320mm |
Performance |
Hot bath |
Preheat temperature range |
+80ºC~+200ºC |
Temperature fluctuation |
±2ºC |
Temp.heat-up rate |
Ambient temp.to+150ºC within 90min |
Temp.pull-down rate |
+150ºC to +60ºC within 60min |
Cold bath |
Precool temperature range |
-65ºC~0 |
Temperature fluctuation |
±2ºC |
Temp.heat-up rate |
-65ºC to 0 within 60min |
Temp.pull-down rate |
Ambient temp.to -65ºC within 120min |
System |
Circulation system |
Sirocco fan |
Heating system |
SUS#304 stainless steel high-speed heater |
Cooling system |
Imported compressor,Tecumseh compressor(or Bizer Compressor),finned type evaporator,air(Water)-cooling condenser |
Controller |
TEMI990,8226,8227,8229 |
Thermal shock range |
-65.00ºC~00.00ºC/+600.00ºC~150.00ºC |
Testing time |
5min |
5min |
Transfer time |
Approximately 10 seconds |
Temp.resolution |
0.1ºC / 1 min |
Specimen Basket size(mm) |
100*180*200mm |
160*180*350mm |
Specimen basket load capacity |
1C 2Kg |
1C 5kg |
Controller |
Color TFT LCD panel(6.5inch) |
Power supply |
AC 1Ψ 220V;3Ψ 380V 60/50Hz |