| Usage: | Powder Coating, Electrical Insulating Varnish, Boat Paint, Road Marking Paint, Car |
|---|---|
| Color: | Antique Silver (Black Base) |
| Appearance: | Powder |
| Method: | Spray |
| Components: | Film Forming Matter |
| Main Raw Material: | Polyester Resin |
| Samples: |
|---|
| Customization: |
|---|
Suppliers with verified business licenses
Audited Supplier DESCRIPTON
Antique silver powder coating can cause some difficulty for painters. The fact is that the same powder may have different shades on the surface. This is due to the fact that the composition of the paint contains a two-component pigment whose materials do not dissolve into each other. Therefore, it is important to comply with a number of conditions under which the paint will have a constant uniform shade.
First, we emphasize that before painting it is necessary to properly prepare the surface. Without it, any powder paint, not just Antique, will go bad. If there are defects on the surface, such as cracks or scratches, it is necessary to drill it. Secondly, for qualitative application of this type of paint it is necessary to observe also specific conditions:
The heating mode in the polymerization furnace must always be identical. The faster the heating occurs, the smaller the coating structure becomes. The corona electrode should have approximately the same voltage. The color of the coating depends on the orientation of the metal particles. And it depends on the voltage. The best voltage for such a powder is 20-25 kV. The coating layer should be at least 80-100 microns. This will make the structure better visible. The ratio of fresh powder to that of the recovery system must be at least 3:1. By following our tips, you will be able to get the perfect Antique structure on your surface.
ADVANTAGES
More Durable
More Environmental Friendly
Powder helps reduce the health hazard to operators
With powder, processing time is reduced
With powder, the air requirements are reduced - more cost savings
Powder is cleaner to use
SPECIFICATION
|
Product details |
|
|
Product Name |
Antique silver powder coating |
|
blueMaterial |
epoxy polyester |
|
Color |
silver |
|
Gloss level |
50-90° |
|
Particle Size |
Average 32-42μm |
|
Specific Gravity |
1.2-1.7g per cubic meter |
|
Coverage |
8-10 square meters per Kg at 60-90 μm film thickness |
|
film thickness |
Not less than 100μm |
|
Powder coated Film Mechanical Properties |
|
|
Adhesion |
Cross-cut(2mm),no loss of adhesion |
|
Impact Resistance |
Direct impact 50kg/cm |
|
Pencil Hardness |
1H-2H |
|
Cupping Test |
6mm Mandrel |
|
Bending Test |
5mm |
|
Powder Coated Film Chemical Resistance |
|
|
Salt Spray Test |
5% NaCl Solution for 500 hours - No change |
|
Acid Resistance |
5% NaCl Solution for 500 hours - No change |
|
Alkali Resistance |
3% NaOH for 240 hours dip test - No change |
|
Storage Stability |
|
|
Store in ventilated, dry, clean room, temperature < 25ºC |
|
|
Relative humidity 50-65% |
|
|
Away from direct sunlight, fire, heat |
|
|
Away from direct sunlight, fire, heat |
|
Suppliers with verified business licenses
Audited Supplier 
){kind=link}
){kind=link}