Aluminum Full View / See-Through / Frosted / Mirror Tempered Glass Sectional Automatic Garage Doors

Installing a sectional garage door is a task that requires careful attention to detail and the following of safety precautions.

Here is a general guide to help you with the installation process.
However, it's important to note that specific instructions can vary depending on the make and model of your garage door, so always refer to the manufacturer's manual for precise steps.
 

Tools and Materials You'll Need:
- Sectional garage door panels
- Garage door opener (if not already installed)
- Garage door tracks
- Garage door rollers
- Torsion spring system or extension springs
- Hardware (nuts, bolts, screws, brackets, etc.)
- A sturdy ladder
- Measuring tape
- Level
- Pencil
- Hammer
- Screwdriver
- Wrench
- Drill
- Safety glasses and gloves

Step-by-Step Installation Guide:

# Step 1: Prepare the Workspace
- Clear the garage and ensure there is enough space to work around the door opening.

# Step 2: Assemble the Door Panels
- Lay out all the panels on a flat surface and connect them according to the manufacturer's instructions. This usually involves sliding the panels together with interlocking joints.

# Step 3: Install the Door Tracks
- Measure and mark the positions for the tracks on the garage walls.
- Use a level to ensure the tracks are straight and parallel.
- Secure the tracks to the walls with brackets and screws.

# Step 4: Attach the Door to the Tracks
- Lift the door and carefully slide it onto the tracks. This may require two people.
- Ensure the door is properly seated and rolls smoothly on the tracks.

# Step 5: Install the Torsion Spring System or Extension Springs
- This is a critical step that requires safety precautions. If not done correctly, springs can cause serious injury.
- For torsion springs, mount them to the header bracket above the door opening and attach the winding cones to the shaft.
- For extension springs, install them horizontally on the tracks above the door, with one spring on each side.

# Step 6: Attach the Bottom Brackets
- Secure the bottom brackets to the bottom panel of the door. These brackets will connect the door to the opener's trolley system.


# Step 7: Install the Garage Door Opener
- If you're installing a new opener, follow the manufacturer's instructions for mounting it to the ceiling and connecting it to the door's trolley system.
- Test the opener to ensure it operates the door smoothly and safely.

# Step 8: Adjust the Door Balance
- Disconnect the opener and manually lift the door to check its balance. The door should be balanced so that it doesn't feel too heavy or too light when lifting.
- Adjust the springs if necessary to achieve balance.

# Step 9: Install Safety Features
- Install safety sensors at the bottom of the tracks to prevent the door from closing on objects or people.

# Step 10: Test the Door Operation
- Reconnect the opener and test the door several times to ensure it opens and closes smoothly.
- Test the automatic reverse feature by placing a wooden block under the door as it closes. The door should reverse when it meets resistance.

# Step 11: Final Adjustments and Cleanup
- Make any final adjustments to the door and opener settings.
- Clean up the workspace and dispose of any packaging materials.

 Safety Precautions:
- Always wear safety glasses and gloves when working with garage doors.
- Do not attempt to adjust or install springs without proper training or experience.
- If you are unsure about any step, consult a professional.

Remember, this is a general guide and may not cover all the specifics of your particular garage door model. Always refer to the manufacturer's instructions for the most accurate information. If you're not comfortable with the installation process, it's best to hire a professional to ensure the job is done safely and correctly.