Yongzhou, Hunan, China
Member Since: 2007
Business Type: Trading Company
Wall or Ceiling mounted type
Light source;10LED 2PCSX2W
Lead Acid Battery 6A 4 AH
Emergency Duration: > 5 Hours
24Hours recaharge time, after 300 minutes discharging
Test Switch And charge Rate indicator
Low Voltage Batter Disconection
Products size: 30.8*14*10.1CM
2.When using electrical equipment, basic safety precautions should always be followed including the following:
1. Review the diagrams thoroughly before beginning.If you feel you do not have electrical wiring experience,
refer to a do-it-yourself wiring handbook or have your fixture installed by a qualified licensed electrician.
2. All electrical connections must be in accordance with local codes,ordinances,and the National Electric Code.
If you are unfamiliar with methods of installing electrical wiring,secure the services of a qualified licensed
3. Before starting the installation,disconnect the power by turning off the circuit breaker or removing the
appropriate fuse at the fuse box .Turning the power off using the light switch is not sufficient to prevent
4. Do not use outdoors.
5. Do not let power supply cords touch hot surfaces.
6. Do not mount near gas or electric heaters.
7. Use caution when servicing batteries.Battery acid can cause burns to skin and eyes.If acid is spilled on skin or in eyes,flush acid with fresh water and contact a physician immediately.
8. Equipment should be mounted in location and at heights where it will not readily be subject to tampering by unauthorized personnel.
9. The use of accessory equipment not recommend by the manufacturer may cause an unsafe condition.
10. Do not use this equipment for other than intended use.
11. All servicing should be performed by qualified personnel only.
12. Allow battery to charge for 24 hours before first use.
13. Use flexible conduit only.
Connect blue wire lead from fixture to white(neutral) wire supply feed from circuit. Connect black 120V or red 277V(depending on supply voltage)wire lead from fixture to black(hot) wire from supply circuit.Use U.L. Listed wire connectors suitable for the size,type,and number of conductors.No loose strands or loose wire should be present. Secure wire connectors with U.L listed electrical tape.
1. Insert screwdriver into the slot between lens and light head body and then push gently to remove lens.
2. Install led.
CAUTION:DO NOT EXCEED RECOMMENDED MAXIMUM WATTAGE.(3.2V2W)