Rugged and reliable, this portable multifunction vibration meter checks bearings and overall vibrations. Get quantifiable information on the overall health of motors and other rotating equipment with this vibration screening device that features the powerful Fluke Connect software.
Ideal for frontline mechanical troubleshooting teams, this vibration meter allows to wirelessly share measurements, create work orders, and report potential problems with Fluke Connect.
Features
- Innovative sensor design minimizes measurement variations caused by device angle or contact pressure
- Consistent data quality at both low and high frequency ranges
- Four-level severity scale assesses urgency of problems for overall vibration and bearing condition
- Exportable data via USB
- Trending in Microsoft® Excel using built-in templates
- Units of measurement: Acceleration: g, m/sec2; Velocity: in/sec, mm/sec; Displacement: mils, mm
- Crest Factor+ technology provides reliable bearing assessment using direct sensor tip measurements between 4,000 Hz and 20,000 Hz
- Coloured lighting system (green, red) and on-screen comments indicate how much pressure needs to be applied to take measurements
- Temperature measurement with Spot IR Sensor increases diagnostic capabilities
- On-board memory holds and saves up to 3,500 measurements
- Audio output for listening to bearing tones directly
- External accelerometer support for hard to reach locations
- Flashlight for viewing measurement locations in dark areas
- Large screen with high resolution for easy navigation and viewing
Fluke 805 FC Vibration Meter with Fluke Connect Compatibility
- 805 FC Fluke Connect Vibration Meter
- Innovative sensor design minimizes measurement variations caused by device angle or contact pressure
- Consistent data quality at both low and high frequency ranges
- Four-level severity scale assesses urgency of problems for overall vibration and bearing condition
- Exportable data via USB
- Trending in Microsoft Excel using pre-built templates
- Overall vibration measurement (10 Hz to 1,000 Hz) for acceleration, velocity and displacement units of measurement for a wide variety of machines
- Crest Factor+ technology provides reliable bearing assessment using direct sensor tip measurements between 4,000 Hz and 20,000 Hz
Make go or no-go maintenance decisions with confidence. The Fluke 805 FC Vibration Meter is the most reliable vibration screening device available for frontline mechanical troubleshooting teams that need repeatable, severity-scaled readings of overall vibration and bearing condition.
Product Parameters
Low Frequency Range (overall measurement) |
10 to 1000 Hz |
High Frequency Range (CF+ measurement) |
4000 to 20,000 Hz |
Severity Levels |
Good, satisfactory, unsatisfactory, unacceptable |
Vibration Limit |
50 g peak (100 g peak-peak) |
A/D Converter |
16-bit |
Signal to Noise Ratio |
80 dB |
Sampling Rate |
Low frequency: 20,000 Hz
High frequency: 80,000 Hz |
Real Time Clock Backup |
Coin battery |
Sensor |
Sensitivity |
100 mV g ±10% |
Measurement Range |
0.01 to 50 g |
Low Frequency Range (overall measurement) |
10 to 1000 Hz |
High Frequency Range |
4000 to 20,000 Hz |
Resolution |
0.01 g |
Accuracy |
At 100 Hz ±5% of measured value |
Amplitude Units |
Acceleration |
g, m/sec2 |
Velocity |
in/sec, mm/sec |
Displacement |
mils, mm |
IR Temperature Measurements |
Range |
-20 to 200°C (-4 to 392°F) |
Accuracy |
±2°C (4°F) |
Focal Length |
Fixed, at ~3.8 cm (1.5") |
External Sensor |
Frequency Range |
10 to 1000 Hz |
Bias Voltage
(to supply power) |
20to 22 V DC |
Bias Current (to supply power) |
Maximum 5 mA |
|
|
Packaging & Shipping