Octylsilane Emulsion Repellent for Limestone and Concrete CAS 2943-75-1 Water-Based Silway 744

Hydrophobic Agent Silway 744 Emulsion of Silane and Siloxane Silicone Water Repellent Stone Cement Plaster Solventless Octyltriethoxysilane

Description

Silway 744 is a water-thinnable, solventless emulsion, based on a mixture of silane and siloxane.

Dilute solutions of Silway 744 serve as highquality, general-purpose water repellents for impregnating and priming mineral surfaces.

Moreover Silway 744 can be used for the mass treatment of non-load bearing concrete products.

Good depth of penetration

Resistance to alkalis

Rapid development of water repellency

Provides good adhesion for paints

Water based and environmentally friendly

Stable in storage, even when diluted

Dilute Silway 744 is an excellent water repellent for many absorbent mineral substrates, such as bricks, sand-lime brick, natural sandstone and mineral plasters. It is not so suitable for less absorbent, dense natural stone, especially limestone, marble and reinforced concrete for bridges and roads.

Owing to its aqueous consistency and storage stability when diluted, Silway 744 is ideal for inplant impregnation of building materials made of clay, aerated concrete, sand-lime brick, fibrous cement, mineral fibers and lightweight aggregate.

Silway 744 may also serve as a water-repellent primer for emulsion paints and plasters, silicone resin emulsion paints and silicone resin plasters. Moreover Silway 744 can be used for the mass treatment of non-load bearing concrete products.

Tap water is suitable for preparing solutions of Silway 744 for use as facade water repellent primer. We recommend an active substance content of 5-10% (dilute the product in the ratio 1:5 to 1:11), the exact figure depending on how absorbent the substrate is.

Apply the ready-to-use solution in the usual way; flooding is the preferred way. Two "wet on wet" coats are needed to ensure complete coverage. Owing to the content of wetting agent in Silway 744, reimpregnation at a later date does not present any difficulties.

If it starts raining, stop treatment and cover the freshly impregnated areas.

For the mass impregnation of concrete products an active agent concentration of 10 % per weight is recommended. The dosage of the diluted product can be related to the overall mass or the amount of binding agents of the concrete product. If related to overall mass, a dosage between 0.1 to 1.0% of the 10% dilution of Silway 744 is recommended.

If related to the amount of binding agent, a dosage between 1.0 to 4.0% of the 10% dilution of Silway 744 is recommended. In order to keep the watercement-ratio on a constant level, reduce the amount of mixing water by the amount of water added with the diluted emulsion.

Even though an evaluation exhibited no negative influence of Silway 744 on the mechanical properties of selected concrete recipes, an independent evaluation of the mechanical properties is recommended.

Packing

200L or IBC tanks

Storage

Avoid children coming into contact with this product

Being storage in closed containers

Avoid the eyes or ingested

Shelf Life

12 months